Roof repairs in Brisbane

What we repair

Most roof leaks start small. A cracked tile, a gap in the ridge capping or a rusted screw lets in a little water each time it rains, and that water often travels along timbers before it shows up as a stain on the ceiling. We look for where the water is actually getting in, not just where it drips.

• Leak tracing and sealing
• Loose, cracked or slipped tiles
• Ridge capping and flashings around chimneys, walls, vents and skylights
• Screw and seal checks on metal roofs
• Valley repairs where two roof sections meet

How a roof repair works with RA Roofing

1. Tell us what you are seeing

Call or send a message with your suburb, roof type if you know it, and a short note about the leak or damage. Photos from the ground help.

2. We inspect and explain

We check the roof, find the cause and take photos of problem spots when useful. You get a plain English explanation of what we found.

3. Clear quote, then the fix

You get a clear quote covering parts, labour and timeline. If a small fix will do, we say so. Once the work is done we clean up and follow up to make sure the leak is gone.

Repair or replace?

If one area leaks or a few tiles are cracked, a repair is usually enough. If leaks keep coming back, the roof is very old, or large sections are worn or rusted, a roof replacement may be better value over time. We give you an honest view either way.

Metal and tile roof repairs

We repair both metal and tile roofs across Brisbane. On metal roofs the usual culprits are worn screws and seals, rust and lifted flashings, covered in more detail on our metal roofing page. On tile roofs it is often cracked tiles and tired ridge pointing, explained on our tile roof repairs page.

If your leak started after a storm, see storm damage roof repairs for what to do first.